Using Reactor not TP connection

[Frank68]

Greetings

I am using reactors to supervise only the inputs on board, not having connected the TP I always get the error message when I connect and the CPU load is always high, if I switch to IP everything works, without problems, scripts etc. etc .., even remote access with ZeroTier

Thank you

[Daniel]

This is correct, you should select knx ip when tp is not used.

[admin]

High CPU load is caused by something else not by having KNX/TP disconnected. Install the Group monitor app and check if you have any duplicate telegrams.

[Frank68]

High CPU load is caused by something else not by having KNX/TP disconnected. Install the Group monitor app and check if you have any duplicate telegrams.

i don't use the tp bus, so i could set knx / ip instead of tp, would the scripts keep going? I guess yes, my only question is that I have 3 REACTORS that use the same group addresses, they are not networked with each other, but they use zerotier as a VPN not that having the same group addresses creates conflicts for me, not should they since the vpn e'punto punto?

A thousand thanks

[admin]

Scripts don't rely on the KNX connection to work. Multicast (KNX/IP) is not sent to ZeroTier by default so multiple devices on the same ZeroTier network won't receive KNX/IP telegrams from others.

[Frank68]

Scripts don't rely on the KNX connection to work. Multicast (KNX/IP) is not sent to ZeroTier by default so multiple devices on the same ZeroTier network won't receive KNX/IP telegrams from others.

perfect thank's