1-wire tab is no longer visible in LM interface

[ro_ki@tut.by]

Hello,

After SW upgrade I do not see 1-wire tab in LM settings.
I still have some 1-wire mapping working fine but can't find where it is stored now.

HW: LM5 Lite + Ext (i.MX6)
SW: 20230420

Best regards,
Kirill

[Daniel]

Since this hardware does not have 1-wire it is no longer present in this fw. You can install it manually from additional packages.

[ro_ki@tut.by]

Daniel, actually I have LM5 DW1 with 1-wire output.
Did I select a wrong firmware?

[Daniel]

Looks like as above you wrote this HW: LM5 Lite + Ext (i.MX6)

[ro_ki@tut.by]

Yes, it is misleading . Text above is copied from System Upgrade window .
The device itself has LM5p2-DW1 tag on it and 2 1-wire connections.

[Daniel]

Yes you are right, try installing fw again or the package manually, something seems broken.

[ro_ki@tut.by]

Thank you , which package you would recommend to install?

[Daniel]

https://dl.openrb.com/lm-23-imx6/pkg/
genohm-scada-w1_20181221

[ro_ki@tut.by]

Thank you, it works. All the best!