15.07.2023, 06:06
Hello
i am looking for a solution. I made two scenes for my stairwell, these are triggered by motion detector 1 scene 1 and motion detector 2 scene 2. I set the scenes in the scene module. But I would like to only trigger the group addresses where 1 or >1% are stored, since the same group addresses are in both scenes I would like to avoid switching them off. First, when I trigger scene 3, all group addresses are switched off. how can this be implemented
i am looking for a solution. I made two scenes for my stairwell, these are triggered by motion detector 1 scene 1 and motion detector 2 scene 2. I set the scenes in the scene module. But I would like to only trigger the group addresses where 1 or >1% are stored, since the same group addresses are in both scenes I would like to avoid switching them off. First, when I trigger scene 3, all group addresses are switched off. how can this be implemented
