This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Gateway v
DALI can't find any devices

Threaded Mode
DALI can't find any devices
KoBra Offline
Member
Posts: 117
Threads: 21
Joined: Apr 2018
Reputation: 2
#1
28.08.2023, 14:14
Dears, i am connecting a Trilux light to to the logic machine and when i scan, the LM is unable to find any devices. Anyone an idea?
Find
Reply
admin Offline
Administrator
Posts: 7758
Threads: 42
Joined: Jun 2015
Reputation: 447
#2
28.08.2023, 14:17
Which DALI power supply are using? See if you can control the ballast using broadcast command. Also check that the device is not DALI2.
Find
Reply
KoBra Offline
Member
Posts: 117
Threads: 21
Joined: Apr 2018
Reputation: 2
#3
28.08.2023, 14:27
(28.08.2023, 14:17)admin Wrote: Which DALI power supply are using? See if you can control the ballast using broadcast command. Also check that the device is not DALI2.

integrated in the trilux light so i can't see it. I think it is DALI2. Is this not working?
Find
Reply
admin Offline
Administrator
Posts: 7758
Threads: 42
Joined: Jun 2015
Reputation: 447
#4
30.08.2023, 07:41
At this moment CANx-DALI can only receive DALI2 frames from the bus. Full DALI2 support with addressing and control is not fully implemented yet.
Find
Reply
Novodk Offline
Member
Posts: 77
Threads: 20
Joined: Apr 2022
Reputation: 0
#5
30.08.2023, 07:52
(28.08.2023, 14:27)KoBra Wrote:
(28.08.2023, 14:17)admin Wrote: Which DALI power supply are using? See if you can control the ballast using broadcast command. Also check that the device is not DALI2.

integrated in the trilux light so i can't see it. I think it is DALI2. Is this not working?

Are you sure there is an integrated DALI psu in the trilux light? I have installed a lot of DALI lights, and I have never seen one with an integrated psu.
Measure the voltage of your DALI line just to be sure, it should be between 15 - 22 V DC.
Find
Reply


Forum Jump: