30.12.2025, 10:19
Hi, I have an installation where i need to use mostly zigbee devices so i bought an rs232 gateway and a bunch of devices but i am having a few problems with some of them, i will pute them below
- wall outlet aqara h2: as long as i just read info from this device there is no problem but if I try to switch on or off the plug nothing happens but i get the correct status update. Is this a problem with the plug itself, or something else?
- window sensor aqara t1: i have linked group addresses to detect the open window. I can see the zigbee device updating once i open the window but it does not update the group address
- shutter actuator VIMAR 14594.0: It does not connect while having an open network. I believe it is not in the list of supported devices, can you add those?
- deviatore connesso VIMAR 14592.0: Same thing as the device above, can this be added to the supported devices?
LM firmware: 20251204
Zigbee App: 20251208
- wall outlet aqara h2: as long as i just read info from this device there is no problem but if I try to switch on or off the plug nothing happens but i get the correct status update. Is this a problem with the plug itself, or something else?
- window sensor aqara t1: i have linked group addresses to detect the open window. I can see the zigbee device updating once i open the window but it does not update the group address
- shutter actuator VIMAR 14594.0: It does not connect while having an open network. I believe it is not in the list of supported devices, can you add those?
- deviatore connesso VIMAR 14592.0: Same thing as the device above, can this be added to the supported devices?
LM firmware: 20251204
Zigbee App: 20251208
