Dimmer in Mosaic

[kenjirosama]

Hi
 
I am trying to use Mosaic to dim my spotlights.
Everytime I try I can only get the lights to turn On or Off.
What type of Dimmer Object should I use?
In ETS it looks like a 3-bit control 3.007  but even if I use that object nothing changes.
I am using ABB Dali and not the one in my LM5. 


Thx!
/Adam

[Tokatubs]

Hi
 
I am trying to use Mosaic to dim my spotlights.
Everytime I try I can only get the lights to turn On or Off.
What type of Dimmer Object should I use?
In ETS it looks like a 3-bit control 3.007  but even if I use that object nothing changes.
I am using ABB Dali and not the one in my LM5. 


Thx!
/Adam

The dimmer uses 1 byte value and status.

   

[Daniel]

You should use 1 byte as it is in the widget. It is much easier to do it via slider. The one bit is to turn it ON/OFF while pressing the icon inside slider button.

[kenjirosama]

Thank you very much for your quick respons!!

Works like a charm!!
Many thanks!!!

[nosek]

Probably I do something wrongly but my KNX dimming devices work with 3-bit control 3.007 only. How to control them from Mosaic widgets?
Thank you.
Vaclav

[Daniel]

I never heard about such dimmer, which one is ti?

[nosek]

JUNG 3602 REG
Also all my wall controllers (Gira) work in this mode. It is not about sending of absolute dimming value but only request of increasing or decreasing step.

---

https://www.jung.de/en/722/downloads/tec...REG&rpp=10

[Daniel]

This is what I meant above to use absolute dimming value. It is much more convenient and faster way of setting desired value instead of the step commands. At this moment of time I see no way to make it working properly in Mosaic. I will add to our development list demand for such widget but right now I would recommend you to use absolute dimming and a slider.

[Tokatubs]

JUNG 3602 REG
Also all my wall controllers (Gira) work in this mode. It is not about sending of absolute dimming value but only request of increasing or decreasing step.

---

https://www.jung.de/en/722/downloads/tec...REG&rpp=10

I follow your link, and imported into ETS5. But i cant see why you wont be able to add this into Mosaic. Both 1 bit and 1 byte is there. Same for status object. Or is it i that dont understand your problem.

   

[nosek]

I have in my ETS project brightness value signed like "STATUS" object - it didn't occur to me send there some value.... Stupid mistake.
Surely for Mosaic this is suffitient solution. 3-bit control 3.007 (dimming) is usable e.g. for full control of dimmable light by one wall push button only.
Sorry and thank you.