This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Hardware v
KNX/TP: Disconnected

Threaded Mode
KNX/TP: Disconnected
jmir Offline
Member
Posts: 234
Threads: 55
Joined: Sep 2015
Reputation: 0
#1
16.10.2024, 12:41
Hi,
We've have a device that has been working fine for years, and now is getting this alerts:
   

When connecting to the bus (through LM) using ETS, and when we read device states, most responses are lost... 
Can it be a SD card issue? Or what can be happening?

Thanks.
Find
Reply
Daniel Offline
Administrator
Posts: 4533
Threads: 23
Joined: Aug 2017
Reputation: 203
#2
16.10.2024, 12:48
It is most likely too big bus traffic.
------------------------------
Ctrl+F5
Find
Reply
jmir Offline
Member
Posts: 234
Threads: 55
Joined: Sep 2015
Reputation: 0
#3
16.10.2024, 14:55
(16.10.2024, 12:48)Daniel Wrote: It is most likely too big bus traffic.

But when I connect using ETS I can't see a lot of traffic...
Find
Reply
Daniel Offline
Administrator
Posts: 4533
Threads: 23
Joined: Aug 2017
Reputation: 203
#4
16.10.2024, 15:20
What is the bus voltage next to LM? Check the KNX connector.
------------------------------
Ctrl+F5
Find
Reply
jmir Offline
Member
Posts: 234
Threads: 55
Joined: Sep 2015
Reputation: 0
#5
16.10.2024, 15:41
(16.10.2024, 15:20)Daniel Wrote: What is the bus voltage next to LM? Check the KNX connector.

30.2V
Find
Reply
Daniel Offline
Administrator
Posts: 4533
Threads: 23
Joined: Aug 2017
Reputation: 203
#6
16.10.2024, 16:04
Do you have another KNX psu to try?
------------------------------
Ctrl+F5
Find
Reply
jmir Offline
Member
Posts: 234
Threads: 55
Joined: Sep 2015
Reputation: 0
#7
17.10.2024, 04:57
(16.10.2024, 16:04)Daniel Wrote: Do you have another KNX psu to try?

Not at the moment... When I go again to the installation I'll try and let you know if it's solved or not.
Thanks.
Find
Reply


Forum Jump: