This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

1-wire stop reporting
#1
Hi, I have been using the LM with 1-wire for 6-7 years now, and it suddenly stopped reporting.

   

Could it be a faulty sensor causing issues for the remaining two, or do you have any suggestions?
Reply
#2
Start by checking the voltage on both 1-wire terminals - +5V and DATA. Then disconnect sensors one by one and check if other sensors can be read.
Reply


Forum Jump: