13.12.2018, 16:55
(This post was last modified: 13.12.2018, 16:58 by Erwin van der Zwart.)
Hi,
Isn’t this just a basic KNX device question?
Check first the parameters of the sending device (Basalte) and if there is no delay set for long push then i would monitor the bus on general traffic load and check what side is causing the delay and contact the manufacturer Jung or Basalte.
BR,
Erwin
Isn’t this just a basic KNX device question?
Check first the parameters of the sending device (Basalte) and if there is no delay set for long push then i would monitor the bus on general traffic load and check what side is causing the delay and contact the manufacturer Jung or Basalte.
BR,
Erwin