19.12.2018, 13:13
HI
I have curently installed 1 LM5 in an exsisting knx installation.
The LM is located on a new backbone 0.0.0 because we needed a new area.
when i connect the exsisting knx line/area to the LM, the LM shows up under device's in programmig mode.
Some thoughts?
i Know it's the LM because i changed the knx addresse and it still shows up under device's in programming mode with the new address.
I have curently installed 1 LM5 in an exsisting knx installation.
The LM is located on a new backbone 0.0.0 because we needed a new area.
when i connect the exsisting knx line/area to the LM, the LM shows up under device's in programmig mode.
Some thoughts?
i Know it's the LM because i changed the knx addresse and it still shows up under device's in programming mode with the new address.