06.04.2019, 20:56
(05.04.2019, 18:46)eirik Wrote: Hi
This is the status flag property of the bacnetobject.
Do you have the option to ignore the stats flag in you scada/plc or does this behavior cause some error in your config?
I have not used that siemens device.
Check out this thread: https://forum.logicmachine.net/showthrea...net+status
The reason for this behavior are explained on page 2 in this thread.
Eirik
It's related to software from Siemens Xworks.. Cfc. So I guess the possibility is there. Will check this out. It's gives an alarm to the scada system every time the value goes missing.
We have been using an Siemens pxc.001 for Knx integrations, and was thinking about using the Lm for the same. But after testing just 5 points I need to resolve this before taking this any bigger. So far not impressed.
Thanks for reply Eirik.