06.05.2016, 09:17
(06.05.2016, 06:16)edgars Wrote: LM5 is an upcoming device. Peripherial are similar to LM4, but there are the following major add-ons:
- 24V output with voltage and current monitoring max 1 A e.g. to interconnect with KNX Choke and see KNX bus current/voltage
- configurable RS485 termination resistors
- Pover-over-Ethernet support for powering the device
- new enclosure with better heating dissipation
There are planned two versions of CPU module for this device:
- regular CPU which we use in all other LMs based on Freescale i.MX28
- powerful CPU module based on Freescale i.MX6 which is 2.5x more faster for integer calculation and 20x faster for floating calculation
I update my LM4 and I can't give to the specified user permission for no partial visualisation pages only Full or None. Can you check Edgars this issue?