07.11.2019, 18:56
(This post was last modified: 08.11.2019, 06:47 by PassivPluss.)
I have two json modbus profiles on a LM5 lite. One rtu 9600 baud and one tcp. Tcp working great but rtu sometimes failing. (Red in modbus window)
I am using pts cable. About 30 meters.
Has the LM built in eol resistors?
Will try to put in this tommorow and not sure if i have to have in both ends.
Does the new rc of firmware have improvements in modbus rtu?
And the scripts above to check TCP and RTU status. Can they make the RTU connection go bad.
I am using pts cable. About 30 meters.
Has the LM built in eol resistors?
Will try to put in this tommorow and not sure if i have to have in both ends.
Does the new rc of firmware have improvements in modbus rtu?
And the scripts above to check TCP and RTU status. Can they make the RTU connection go bad.