This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › General v
KNX poling on low traffic

Linear Mode
KNX poling on low traffic
Dario Offline
Junior Member
Posts: 23
Threads: 7
Joined: May 2019
Reputation: 0
#5
03.04.2020, 10:46
Hi,

I have very big plant with about 1000 Dali address, eachone have 2 GA (fb on/off, fb dimmer), when we turn off or turn on all lights we have overload.

We have already entered some delays but this is not sufficient.
Find
Reply


Messages In This Thread
KNX poling on low traffic - by Dario - 01.04.2020, 16:16
RE: KNX poling on low traffic - by admin - 02.04.2020, 06:03
RE: KNX poling on low traffic - by Dario - 02.04.2020, 22:06
RE: KNX poling on low traffic - by Dario - 03.04.2020, 10:46
RE: KNX poling on low traffic - by AlexLV - 03.04.2020, 12:30
RE: KNX poling on low traffic - by Dario - 03.04.2020, 12:42
RE: KNX poling on low traffic - by AlexLV - 03.04.2020, 13:11
RE: KNX poling on low traffic - by Dario - 03.04.2020, 14:19
RE: KNX poling on low traffic - by Dario - 06.04.2020, 09:28
RE: KNX poling on low traffic - by Daniel - 06.04.2020, 09:46

Forum Jump: