This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

How to control the KNX bus via SMS and send notices via SMS?
#33
(27.06.2016, 17:15)ferrim Wrote:
(27.06.2016, 14:52)quản trị Wrote: Additional capacitors for 5V supply might work. But are you actually having any disconnects? These measures are optional and are not needed usually.

With Huawei USB sticks I've never seen a disconnect while with the cheap ones sometimes is happened during SMS receiving or transmitting.
From a few hours I'm trying the USB-CAP Olimex adapter and seems to work well...
Regards,
Marcello

Hi every one.


I'm using LM3 reactor are using sim 3g modem to send SMS but I encountered this phenomenon hope everyone help.

When using the LM message " SMS handler lost connection" according to attachments .

When converting " comport = ' ttyUSB0 ' " to " comport = ' ttyUSB2 ' " or " comport = ' ttyUSB1 " then turn off again " Script " the normal message .

Has anyone encountered this case does not help.


Thank you.

Attached Files Thumbnail(s)
   
Reply


Messages In This Thread
RE: How to control the KNX bus via SMS and send notices via SMS? - by luanpt - 15.07.2016, 04:07

Forum Jump: