03.07.2020, 17:45
Hi all,
I bought a Doorbird Video Doorstation D1101V wich can open the sliding gate with the integrated relay and the Doorbird IP I/O expansion module wich allows me to also open the 2 garage doors and the front door. For the moment the garage doors are controlled by the remotes and KNX buttons inside the garage over a switch actuator with a script attached: ON - 0.5s delay - OFF.
Is it possible and can someone help me to reconnect the KNX buttons in the garage (trough script or something) so I can control the garage doors as before. It should be possible trough API with
So what i'm looking for I think is to put this command behind a physical button.
Thx in advance
I bought a Doorbird Video Doorstation D1101V wich can open the sliding gate with the integrated relay and the Doorbird IP I/O expansion module wich allows me to also open the 2 garage doors and the front door. For the moment the garage doors are controlled by the remotes and KNX buttons inside the garage over a switch actuator with a script attached: ON - 0.5s delay - OFF.
Is it possible and can someone help me to reconnect the KNX buttons in the garage (trough script or something) so I can control the garage doors as before. It should be possible trough API with
Code:
http://<device-ip>/bha-api/open-door.cgi?<parameter>=<value>Thx in advance
Novice DIY with a HL and KNX basics trying to ...