This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Scripting v
KNX Init allignment problem

Linear Mode
KNX Init allignment problem
Erwin van der Zwart Offline
Senior Member
Posts: 1764
Threads: 6
Joined: Jul 2015
Reputation: 117
#5
27.07.2016, 11:14
Hi,

Where do you see the requests / response ? Ets monitor?

If yes do you connect over HL/SL or USB?

Does none work or just some?

Did you check all read flags inside ets project?

Do you use line couplers?

Is physical address of HL/SL set to the correct line?

What FW are you using? 

BR,

Erwin van der Zwart
Schneider Electric
Find
Reply


Messages In This Thread
RE: KNX Init allignment problem - by admin - 26.07.2016, 08:48
RE: KNX Init allignment problem - by Erwin van der Zwart - 27.07.2016, 11:14
RE: KNX Init allignment problem - by admin - 29.07.2016, 08:42

Forum Jump: