does knxlib.ping('1.1.0') require TP1 connection?
|
does knxlib.ping('1.1.0') require TP1 connection?
|
12.08.2020, 11:15
(12.08.2020, 11:05)Daniel. Wrote: You can disable KNX IP, or change multicast.I don't think I understand. I use KNX IP Routing because TP1 causes telegram repeats. I also use a slightly different Multicast IP, one that's used throughout the installation, of course. Or are you saying I could use an IP tunnel? 
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
does knxlib.ping('1.1.0') require TP1 connection? - by kropfm - 12.08.2020, 11:01
RE: does knxlib.ping('1.1.0') require TP1 connection? - by Daniel - 12.08.2020, 11:02
RE: does knxlib.ping('1.1.0') require TP1 connection? - by kropfm - 12.08.2020, 11:05
RE: does knxlib.ping('1.1.0') require TP1 connection? - by Daniel - 12.08.2020, 11:05
RE: does knxlib.ping('1.1.0') require TP1 connection? - by kropfm - 12.08.2020, 11:15
RE: does knxlib.ping('1.1.0') require TP1 connection? - by Daniel - 12.08.2020, 11:18
RE: does knxlib.ping('1.1.0') require TP1 connection? - by kropfm - 12.08.2020, 11:29
RE: does knxlib.ping('1.1.0') require TP1 connection? - by Daniel - 12.08.2020, 11:31
RE: does knxlib.ping('1.1.0') require TP1 connection? - by kropfm - 12.08.2020, 11:39
|
