Nano Temp Inveo - Temperature Sensor

[Hugo]

Preface:

Manual:
http://download.inveo.com.pl/manual/nano...ual_en.pdf

Module:
https://www.tme.eu/at/en/details/nano-te...nano-temp/

Note: I try out several third-party sensors, but only the original Inveo sensors are working.

Sensors:
https://www.tme.eu/at/en/details/sensor-...nveo/ds-1/
https://www.tme.eu/at/en/details/sensor-...nveo/ds-5/
https://www.tme.eu/at/en/details/sensor-...veo/ds-10/

Question:

By the following .jons i get the output of 231°C (since it`s x 10 in accordance to the Manual)

{
  "manufacturer": "Hugo",
  "description": "Nano_Temp_Inveo_V1",
  "mapping": [
    { "name": "Temperatur", "bus_datatype": "int16", "datatype": "int16", "type": "register", "address": 4003, "units": "°C" }
  ]
}


But if i do this, i get the output of 23°C

{
  "manufacturer": "Hugo",
  "description": "Nano_Temp_Inveo_V2",
  "mapping": [
    { "name": "Temperatur", "bus_datatype": "int16", "datatype": "int16", "type": "register", "address": 4003, "value_multiplier": 0.1, "units": "°C" }
  ]
}

How i get the output 23,1°C?