28.01.2021, 09:24
(This post was last modified: 28.01.2021, 09:26 by davidchispas.)
Hello, I have a configuration question for when we have more than 1 LM in the installation.
In this case there are 3 teams.
2 LM (A and B) are connected in the same network but have independent knx bus and 1LM © is in a different network but shares knx bus with LM (B).
LM (A) it has the KNX IP features enabled and LM (B) at the moment not. Both are configured as TP-UART and in the filter table so that they only accept a knx address.
LM © is configured as TP-UART and has KNX IP features enabled, but I would like to assign LM (B) as IP connection.
Can I have any incidence when dumping knx programming or is it okay?
In this case there are 3 teams.
2 LM (A and B) are connected in the same network but have independent knx bus and 1LM © is in a different network but shares knx bus with LM (B).
LM (A) it has the KNX IP features enabled and LM (B) at the moment not. Both are configured as TP-UART and in the filter table so that they only accept a knx address.
LM © is configured as TP-UART and has KNX IP features enabled, but I would like to assign LM (B) as IP connection.
Can I have any incidence when dumping knx programming or is it okay?