28.01.2021, 10:51
(28.01.2021, 09:36)Daniel. Wrote: When two LMs are connected to the same TP then you will create KNX loop. One option is to disable KNX IP on one of them like you did, you can also change multicast address and then they both will send on IP but will not see each other.
If it is as you say that both LMs are on different IP networks then you can just enable the KNX IP
In this case, 2 LMs share the same data network and but different TPs. (They are two different installations) I want to enable KNX IP features in both LMs.
It is enough to enable the IP filters and accept the addresses that I am interested in exchanging or do I need to change something else in the configuration?