Reset POE Port on Unifi Switch - Connecting to a device via SSH Key

[jamesng]

Hi

I'd like to automate the power cycle of a POE port on a Unifi Switch.   The Unifi docs say this can be achieved by connecting to the device via a SSH key and then issuing some telnet commands.   I can run these commands ok from the terminal window of my desktop, however am not to sure how to initial a ssh connection from logic machine / CBUS SHAC.

Here the sequence of commands that run ok from my desktop Mac to power cycle port 15.

Code:

ssh -i /Users/james/.ssh/id_rsa admin@192.168.1.100# telnet localhost 23 enable configure interface 0/15 poe opmode shutdown poe opmode auto exit exit exit telnet localhost 23 exit

Here's the beginnings of my LM script to issue the telnet commands.  Can anyone advise how to modify the script to SSH to the switch with an SSH key (the key is in the id_rsa file in the above example)

Code:

function resetPOESwitchPort(switchport)   local socket = require("socket").tcp() local response, err = socket:connect('192.168.1.100', 23) if response then   -- SSH connection established so issue telnet commands   socket:send('telnet localhost 23\r\n')   response = socket:receive(5)   log(response)   socket:send('telnet localhost 23\r\n')       response = socket:receive(5)   log(response)   socket:send('enable\r\n')       response = socket:receive(5)   log(response)   socket:send('configure\r\n')       response = socket:receive(5)   log(response)   socket:send('interface 0/' .. switchport .. '\r\n')       response = socket:receive(5)   log(response)   socket:send('poe opmode shutdown\r\n')       response = socket:receive(5)   log(response)   socket:send('poe opmode auto\r\n')       response = socket:receive(5)   log(response)   socket:send('exit\r\n')       response = socket:receive(5)   log(response)   socket:send('exit\r\n')       response = socket:receive(5)   log(response)   socket:send('exit\r\n')       response = socket:receive(5)   log(response)   socket:send('telnet localhost 23\r\n')       response = socket:receive(5)   log(response)   socket:send('exit\r\n')   response = socket:receive()   log(response)   socket:close()   else     -- No connnection response     log ('Unable to connect to switch')   tcp:close()   end end

Any advice would be greatly appreciated 

Kind Regards
James