22.02.2021, 12:29
(This post was last modified: 22.02.2021, 12:38 by manos@dynamitec.)
Hello Admin and Daniel,
Can the Bacnet client be used to read (get the bacnet IP values and translate it to knx values) and write (get the knx values and translate them to bacnet IP)?
Could I use the Bacnet Server to implement the functions above? Or there is a need of two LMs running one in client mode and one in server mode?
What I need to achieve in the end is a full bi-directional communication with a BMS server over bacnet IP. So that all statuses and feedback values can be sent to the BMS server from the KNX and also commands (binary and setpoint values) from the BMS server sent to the KNX.
Is there a limitation for the datapoints for this?
Kind regards.
Can the Bacnet client be used to read (get the bacnet IP values and translate it to knx values) and write (get the knx values and translate them to bacnet IP)?
Could I use the Bacnet Server to implement the functions above? Or there is a need of two LMs running one in client mode and one in server mode?
What I need to achieve in the end is a full bi-directional communication with a BMS server over bacnet IP. So that all statuses and feedback values can be sent to the BMS server from the KNX and also commands (binary and setpoint values) from the BMS server sent to the KNX.
Is there a limitation for the datapoints for this?
Kind regards.