10.10.2016, 14:33
On the thread of Iridium Server and LMx - I would like to have a piece of logic for heating control where I turn on a circulating pump if the boiler is on and there has been a call for heat - 3 KNX group addresses. I would like to do this for several manifolds.
1. I assume I can use the block function to do this? Perhaps you have an example?
2. Can I run such functions whilst running Iridium Server?
3. When I am running Iridium Server and I wish to perform logic functions using KNX group addresses - can I access group addresses from Iridium Server somehow or must I have the local group addresses stored?
4. Is there a way to synchronise group addresses between Iridium Server and local Logic Machine?
1. I assume I can use the block function to do this? Perhaps you have an example?
2. Can I run such functions whilst running Iridium Server?
3. When I am running Iridium Server and I wish to perform logic functions using KNX group addresses - can I access group addresses from Iridium Server somehow or must I have the local group addresses stored?
4. Is there a way to synchronise group addresses between Iridium Server and local Logic Machine?