15.11.2021, 08:52
Hi @all,
I have a Hörmann garage door interface to KNX. The interface doesn’t support an absolut position request to drive the door to an specific position.
Is there any script available to calculate the start / stop objects for the garage door interface based on the requested absolut value and the top/down running time?
Many thanks.
Best Regards
Steffen
I have a Hörmann garage door interface to KNX. The interface doesn’t support an absolut position request to drive the door to an specific position.
Is there any script available to calculate the start / stop objects for the garage door interface based on the requested absolut value and the top/down running time?
Many thanks.
Best Regards
Steffen