This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Scripting v
Send KNX commands to control AHU Controller over MODBUS RTU

Linear Mode
Send KNX commands to control AHU Controller over MODBUS RTU
admin Offline
Administrator
Posts: 7758
Threads: 42
Joined: Jun 2015
Reputation: 447
#6
07.01.2022, 09:43
The actual address for the setpoint can be either 23 or 22. Usually the leading number in the address specifies the function which is used (3 for input register, 4 for holding register).
Find
Reply


Messages In This Thread
RE: Send KNX commands to control AHU Controller over MODBUS RTU - by admin - 07.01.2022, 09:43

Forum Jump: