07.01.2022, 12:09
we're not taking any value to test. we are supposed to send KNX temp value to Modbus by Logic machine. once if we create & convert to modbus values they will scan & check the values for Logic machine device.
Logic machine will be the device which should have the data that to send in MODBUS.
RTU test is where we can scan the register of other device & read those values, in our case we are suppose to give values our Logic macine device to other device over MODBUS.
Logic machine will be the device which should have the data that to send in MODBUS.
RTU test is where we can scan the register of other device & read those values, in our case we are suppose to give values our Logic macine device to other device over MODBUS.