10.03.2022, 11:56
(This post was last modified: 10.03.2022, 11:58 by davidchispas.)
(10.03.2022, 10:55)admin Wrote: It's possible but there are many parameters that can be mapped. Which ones do you need?
Have you got communication working from LM? Can you read register number 0 using read test?
Hi Yes. I have a connection with the team and I have achieved this. I hope it's okay like this.
The data that I usually use in the KNX gateway are these:
System Error (1bit)
System Operation Mode (1Byte)
System Operation Mode Status (1Byte)
Zone 1-6 – On/Off Control (1bit)
Zone 1-6 – On/Off Control Status (1bit)
Zone 1-6 – Temperature Setpoint Control (2Bytes)
Zone 1-6 – Temperature Setpoint Control (2Bytes)
Zone 1-6 – relative Moisture Status (2Bytes)
Zone 1-6 – Local Temperature Control (2Bytes)
Zone 1-6 – Heat Stages Control (1Byte)
Zone 1-6 – Heat Stages Status (1Byte)
Zone 1-6 – Cool Stages Control (1Byte)
Zone 1-6 – Cool Stages Status (1Byte)