Hi.
After several power failures my LSS100100 (HW 1.1) controller is not work propertly: web-interface randomly freezes, blank pages, settings is not stored after reboot. So, i conclude, that SD-card is broken and replaced it with new-one (16 GB samsung 10 class). I flashed SD-card with recovery-image https://www.se.com/hk/en/download/document/AN2_001/ than opened recovery page 192.168.0.10 and chosed new firmware https://www.se.com/ww/en/download/docume...1_X_X-w4k/ process started and than after 2 minutes controller rebooted and now only blinking with two LEDs (LED1 and internal LED) with 3 seconds period. Ethernet LEDs is also off and no pings to 192.168.0.10 presented. What i am doing wrong?
with best regards
Kiryl
After several power failures my LSS100100 (HW 1.1) controller is not work propertly: web-interface randomly freezes, blank pages, settings is not stored after reboot. So, i conclude, that SD-card is broken and replaced it with new-one (16 GB samsung 10 class). I flashed SD-card with recovery-image https://www.se.com/hk/en/download/document/AN2_001/ than opened recovery page 192.168.0.10 and chosed new firmware https://www.se.com/ww/en/download/docume...1_X_X-w4k/ process started and than after 2 minutes controller rebooted and now only blinking with two LEDs (LED1 and internal LED) with 3 seconds period. Ethernet LEDs is also off and no pings to 192.168.0.10 presented. What i am doing wrong?
with best regards
Kiryl