02.08.2022, 13:14
Hello
In a project I have several DMX Lighting units
I should control On/OFF, Dimming, RGBW channels.
based on above information:
1- Could SL do this job Using RS232 Port.
2- Are there any recommended distance between the SL and the DMX endpoint different than 1000m?
3- What are the maximum recommended channels that I shouldn't exceed.
4- In DMX could I set several units with same address to control it as one channel?
In a project I have several DMX Lighting units
I should control On/OFF, Dimming, RGBW channels.
based on above information:
1- Could SL do this job Using RS232 Port.
2- Are there any recommended distance between the SL and the DMX endpoint different than 1000m?
3- What are the maximum recommended channels that I shouldn't exceed.
4- In DMX could I set several units with same address to control it as one channel?
Best Regards,