04.08.2022, 12:40
Hi all,
I want to know if it is possible, via a script, to use LM as a Modbus slave of an EGX150 gateway (Schneider). My project is to simulate an iEM3155 powermeter and to send power values to EGX150 so that it sends them in TCP/IP to another system.
I found a script on the forum, but it is adapted to KNX objects: this is not my case, I have virtual objects in LM.
Thank's in advance for your help.
Have a good end of week.
Dominique
I want to know if it is possible, via a script, to use LM as a Modbus slave of an EGX150 gateway (Schneider). My project is to simulate an iEM3155 powermeter and to send power values to EGX150 so that it sends them in TCP/IP to another system.
I found a script on the forum, but it is adapted to KNX objects: this is not my case, I have virtual objects in LM.
Thank's in advance for your help.
Have a good end of week.
Dominique