LM, EGX150 and PM simulator

[SigmaTec]

Hi all,

I want to know if it is possible, via a script, to use LM as a Modbus slave of an EGX150 gateway (Schneider). My project is to simulate an iEM3155 powermeter and to send power values to EGX150 so that it sends them in TCP/IP to another system.

I found a script on the forum, but it is adapted to KNX objects: this is not my case, I have virtual objects in LM.

Thank's in advance for your help.
Have a good end of week.

Dominique

Ok Admin,

so I may not have the right script. 
Can you tell me one that will allow me to carry out my project? 
LM (simulate a Powermeter as iEM3155) -> EGX150 (gateway) -> Product reading Egx150
I may not have the right script. Can you tell me one that will allow me to carry out my project? LM (simulate a Powermeter) -> EGX150 (gateway) -> Product reading Egx150
All the best
Dominqiue