01.01.2017, 12:37
Hi again,
I've asked in another thread how I can prevent sending a value to KNX TP Network from modbus TCP. In this thread I need to read a value from an KNX Objekt which is set in my SL only. I need it to get the current status.
If I try it to read it in ETS (connected with an KNX USB Device) I get no values. The SLÂ Shows no request to that object.
The SL and my USB device are in the same line (SL = 0.0.1, USB Device 0.0.13). If I change the value in SL the ETS (USB) show me that, but Only reading fails.
The Object in SL:
The Definition in ETS:
The ETS Monitor output:
BR
Habib
I've asked in another thread how I can prevent sending a value to KNX TP Network from modbus TCP. In this thread I need to read a value from an KNX Objekt which is set in my SL only. I need it to get the current status.
If I try it to read it in ETS (connected with an KNX USB Device) I get no values. The SLÂ Shows no request to that object.
The SL and my USB device are in the same line (SL = 0.0.1, USB Device 0.0.13). If I change the value in SL the ETS (USB) show me that, but Only reading fails.
The Object in SL:
The Definition in ETS:
The ETS Monitor output:
BR
Habib