21.09.2015, 13:07
Check network settings in System Config -> Network -> Interfaces -> eth0. You have to set Gateway IP to your router IP, otherwise LogicMachine will only have access to devices in the same local network, but not outside.
Logic Machine Forum
›
LogicMachine eco-system
›
Scripting
Write a code from LM3, to send HTTP commands to a device to control it
Write a code from LM3, to send HTTP commands to a device to control it
|
Write a code from LM3, to send HTTP commands to a device to control it
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Write a code from LM3, to send HTTP commands to a device to control it - by phongvucba - 17.09.2015, 15:03
RE: Write a code from LM3, to send HTTP commands to a device to control it - by admin - 18.09.2015, 06:11
RE: Write a code from LM3, to send HTTP commands to a device to control it - by phongvucba - 21.09.2015, 12:46
RE: Write a code from LM3, to send HTTP commands to a device to control it - by admin - 21.09.2015, 13:07
RE: Write a code from LM3, to send HTTP commands to a device to control it - by phongvucba - 22.09.2015, 12:03
RE: Write a code from LM3, to send HTTP commands to a device to control it - by Hoang189 - 28.09.2015, 09:14
RE: Write a code from LM3, to send HTTP commands to a device to control it - by phongvucba - 30.09.2015, 14:32
|