This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Scripting v
Update after power failure

Linear Mode
Update after power failure
electrokinisi Offline
Junior Member
Posts: 12
Threads: 5
Joined: Apr 2018
Reputation: 0
#3
10.09.2023, 10:22
(07.09.2023, 21:04)Erwin van der Zwart Wrote: Just enable “Read during start-up” in the object properties and make sure the read flag is enabled in the ETS programming so the device object in that group address is allowed to answer.
Thanks for the answer, very useful. But the wiser  is in ups , maybe there is in code to enable reading  when the voltage comes back. 
Thanks in advance .
Find
Reply


Messages In This Thread
Update after power failure - by electrokinisi - 07.09.2023, 16:17
RE: Update after power failure - by electrokinisi - 10.09.2023, 10:22
RE: Update after power failure - by Daniel - 11.09.2023, 09:24
RE: Update after power failure - by admin - 11.09.2023, 09:28

Forum Jump: