22.02.2017, 14:27
(21.02.2017, 18:35)Arnts Wrote:(20.02.2017, 18:34)mlaudren Wrote: Hi,
Crestron use a proprietary protocol.
And they have gateway to other protocols like cresnet-KNX, crestnet-modbus, ...
You could use a crestnet-knx gateway for this. our maybe by ethernet, but I'm not sure you have an open API on the processor...
The point here was to use LM4 as a Crestron --> KNX gw, so that you don`t have to buy both :
So make a connection from Crestron to LM via TCP/IP and read/write to Groupadresses in KNX.
Has this been done?
Didn't understand it properly...
I thought the goal was to control Crestron device from LM.
If it's to control knx From the Crestron processor (trough LM), yes, using the remote API will work fine, or as said by Arnts TCP connection.