19.07.2024, 16:12
Hello,
We are working on a project with 4 lines, 4 IP Routers and 1 LM.
When we configure LM with the following settings*(attached photo), the multicast connection is interrupted and the IP routers are not shown in ETS- KNX Connections. No filters are active.
Why this happens?
Thank you in advance.
We are working on a project with 4 lines, 4 IP Routers and 1 LM.
When we configure LM with the following settings*(attached photo), the multicast connection is interrupted and the IP routers are not shown in ETS- KNX Connections. No filters are active.
Why this happens?
Thank you in advance.