23.08.2024, 17:13
Actually this is a prety complex task. I don't understand why there's no direct support from LM there. You have to do following:
- Users and access rights synchronisation
- Schedulers disabling and synchronisation
- scenes disabling and synchonisation
- Disable all scripts on backup LM that may affect your KNX object state if it's not active
- Disable Modbus IP readings if your device access is limited to one session only.
- swap IP addresses (or use a load balancer instead of direct access)
- Users and access rights synchronisation
- Schedulers disabling and synchronisation
- scenes disabling and synchonisation
- Disable all scripts on backup LM that may affect your KNX object state if it's not active
- Disable Modbus IP readings if your device access is limited to one session only.
- swap IP addresses (or use a load balancer instead of direct access)
LM5Lp, firmware: 2018.08.22 and 2021.12.15, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151 and 4.4.259