This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Visualization v
Change attribute in visu following a knx object

Linear Mode
Change attribute in visu following a knx object
Andrea Becagli Offline
Member
Posts: 50
Threads: 10
Joined: May 2021
Reputation: 1
#1
27.08.2024, 10:47
I have been asked to make some elements of the visualization "read-only" if a specified KNX object is off. Is there a way I can do this?
Find
Reply


Messages In This Thread
Change attribute in visu following a knx object - by Andrea Becagli - 27.08.2024, 10:47

Forum Jump: