04.03.2025, 06:35
Hi to everyone,
I am facing a problem when I am trying to program KNX Devices with ETS and using the LM5 as a KNX/IP Router along with ZeroTier connection. In this project I have 3 lines 1.1.xxx, 1.2.xxx, 1.3.xxx , so I have 2 line couplers working as repeaters at lines 2 and 3. The LM5 is connected on Line 3 and I can only program the devices of line 3 and not the KNX devices connected on lines 1 or 2. Why is this happening? Should I connect it on Line 1 or not? I have change the address inside the LM5 to test it to 1.2.255 or 1.1.255 or 15.15.255 to be able to program each line seperately, but nothing worked for me. Any ideas please?
Thank you in advance!
I am facing a problem when I am trying to program KNX Devices with ETS and using the LM5 as a KNX/IP Router along with ZeroTier connection. In this project I have 3 lines 1.1.xxx, 1.2.xxx, 1.3.xxx , so I have 2 line couplers working as repeaters at lines 2 and 3. The LM5 is connected on Line 3 and I can only program the devices of line 3 and not the KNX devices connected on lines 1 or 2. Why is this happening? Should I connect it on Line 1 or not? I have change the address inside the LM5 to test it to 1.2.255 or 1.1.255 or 15.15.255 to be able to program each line seperately, but nothing worked for me. Any ideas please?
Thank you in advance!