19.03.2017, 22:56
Hi
Can I secure the connection to LM somehow? Now everybody who get access to my network can use his own ETS and modify my KNX devices.
I set "encryption key" in "KNX connection" dialogue and "Enable only secure connection" but I'm still able to connect to KNX bus throw LM from ETS 5.5 via unsecured channel only.
Maybe the problem is I use LM in TP-UART mode?
What is the best practice?
FYI when I unchecked "KNX IP features" my LM got completely frozen. No led lighted. Reset button didn't work. I had to disconnect power supply for turning it on.
Can I secure the connection to LM somehow? Now everybody who get access to my network can use his own ETS and modify my KNX devices.
I set "encryption key" in "KNX connection" dialogue and "Enable only secure connection" but I'm still able to connect to KNX bus throw LM from ETS 5.5 via unsecured channel only.
Maybe the problem is I use LM in TP-UART mode?
What is the best practice?
FYI when I unchecked "KNX IP features" my LM got completely frozen. No led lighted. Reset button didn't work. I had to disconnect power supply for turning it on.
LM5Lp, firmware: 2018.08.22 and 2021.12.15, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151 and 4.4.259