Master Slave with LM5

Linear Mode

Master Slave with LM5

Kuru

Junior Member

Posts: 9
Threads: 2
Joined: Dec 2022
Reputation: 0

24.04.2025, 12:43

Unfortunately, this doesn't work either.
I created a group address with a Boolean value: when set to 0, the Modbus switches off; when set to 1, it indicates that RTU 1 is switched on.
However, it doesn’t work as intended – RTU 1 only starts again after restarting the LM.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Master Slave with LM5 - by Kuru - 06.11.2024, 10:06

RE: Master Slave with LM5 - by Daniel - 06.11.2024, 11:21

RE: Master Slave with LM5 - by Kuru - 06.11.2024, 12:38

RE: Master Slave with LM5 - by Daniel - 06.11.2024, 12:42

RE: Master Slave with LM5 - by Kuru - 07.11.2024, 13:05

RE: Master Slave with LM5 - by Daniel - 07.11.2024, 14:34

RE: Master Slave with LM5 - by Kuru - 24.04.2025, 11:26

RE: Master Slave with LM5 - by Daniel - 24.04.2025, 12:16

RE: Master Slave with LM5 - by Kuru - 24.04.2025, 12:43