|
Master Slave with LM5
|
08.05.2025, 12:53
We tried on same hardware and same firmware, also using your backup and it works fine. I think the issue you have is in pool interval. The slave device might not be able to do the whole read cycle in 1 second and then the daemon is fully occupied. Change it to something longer, there is no need to read the values so often.
------------------------------
Ctrl+F5 |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Master Slave with LM5 - by Kuru - 06.11.2024, 10:06
RE: Master Slave with LM5 - by Daniel - 06.11.2024, 11:21
RE: Master Slave with LM5 - by Kuru - 06.11.2024, 12:38
RE: Master Slave with LM5 - by Daniel - 06.11.2024, 12:42
RE: Master Slave with LM5 - by Kuru - 07.11.2024, 13:05
RE: Master Slave with LM5 - by Daniel - 07.11.2024, 14:34
RE: Master Slave with LM5 - by Kuru - 24.04.2025, 11:26
RE: Master Slave with LM5 - by Daniel - 24.04.2025, 12:16
RE: Master Slave with LM5 - by Kuru - 24.04.2025, 12:43
RE: Master Slave with LM5 - by Daniel - 24.04.2025, 12:45
RE: Master Slave with LM5 - by Kuru - 24.04.2025, 13:02
RE: Master Slave with LM5 - by Daniel - 25.04.2025, 09:09
RE: Master Slave with LM5 - by Kuru - 28.04.2025, 10:52
RE: Master Slave with LM5 - by Daniel - 28.04.2025, 11:01
RE: Master Slave with LM5 - by Kuru - 08.05.2025, 09:16
RE: Master Slave with LM5 - by Daniel - 08.05.2025, 12:53
|
