This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Gateway v
1-wire stop reporting

Linear Mode
1-wire stop reporting
fiLLLip Offline
Junior Member
Posts: 32
Threads: 5
Joined: Apr 2017
Reputation: 1
#3
29.08.2025, 08:56
(05.08.2025, 07:03)admin Wrote: Start by checking the voltage on both 1-wire terminals - +5V and DATA. Then disconnect sensors one by one and check if other sensors can be read.

Voltage was OK. Disconnected all sensors and tested one by one to verify that one of them was faulty. Replaced and now working Smile
Find
Reply


Messages In This Thread
1-wire stop reporting - by fiLLLip - 05.08.2025, 04:24
RE: 1-wire stop reporting - by admin - 05.08.2025, 07:03
RE: 1-wire stop reporting - by fiLLLip - 29.08.2025, 08:56

Forum Jump: