Hi,
I might have jumped the gun on this one.
I have set ETS Paramaters to the exact same for all lights... but they act differently when going from OFF to 1%.
For one object if the value 1% is sent, the lights goes from from OFF and directly to 1%.
For another object if the value 1% is sent, the lights first goes to last dimming value and then really quickly dims down to 1%.
This is within the same DALI driver in ETS, and all my lights uses the same types of TRAFO.
I have further noticed that if the value 2% is sent, then all objects goes directly from OFF to 2%.
Furthermore, if the current value is set to 1%, and I increase it to 2%, the lights dims up, but there is no change in the status object. It still states 1%.
The same goes for, if the value is 2%, and I change it to 1%, the status object is not changed, but the lights still dims down slightly.
Also if the value 50% is written, the status always comes out stating 51% or 49%?????
Anyone knows whats going on?
PS if the same steps are done directly in ETS, then all lights goes from OFF and directly to 1%... so here it works fine...
Also if the value 50% is written, the status always comes out stating 51% or 49%...
BR
Mr.D
I might have jumped the gun on this one.
I have set ETS Paramaters to the exact same for all lights... but they act differently when going from OFF to 1%.
For one object if the value 1% is sent, the lights goes from from OFF and directly to 1%.
For another object if the value 1% is sent, the lights first goes to last dimming value and then really quickly dims down to 1%.
This is within the same DALI driver in ETS, and all my lights uses the same types of TRAFO.
I have further noticed that if the value 2% is sent, then all objects goes directly from OFF to 2%.
Furthermore, if the current value is set to 1%, and I increase it to 2%, the lights dims up, but there is no change in the status object. It still states 1%.
The same goes for, if the value is 2%, and I change it to 1%, the status object is not changed, but the lights still dims down slightly.
Also if the value 50% is written, the status always comes out stating 51% or 49%?????
Anyone knows whats going on?
PS if the same steps are done directly in ETS, then all lights goes from OFF and directly to 1%... so here it works fine...
Also if the value 50% is written, the status always comes out stating 51% or 49%...
BR
Mr.D