16.05.2017, 07:12
Hi,
I am using the LM5 to program my KNX-devices through ETS-software which works as expected.
When using the monitoring in ETS I only get info when using the group-monitor: it shows all group adresses being triggered realtime.
However when I use the bus-monitor nothing shows up? Is this normal behaviour? Or do I need to change a setting in LM to do this.
Thansk, Bart
I am using the LM5 to program my KNX-devices through ETS-software which works as expected.
When using the monitoring in ETS I only get info when using the group-monitor: it shows all group adresses being triggered realtime.
However when I use the bus-monitor nothing shows up? Is this normal behaviour? Or do I need to change a setting in LM to do this.
Thansk, Bart