This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

KNX/TP: Conected
#1
Hi
Can you please give me some clue what can be a source of this message which I see in my alert log?

There's no 'Disconnected' message. I see 'Connected' only which confuses me.
These messages are strange because I don't believe the bus was overloaded in any way at 2:09 AM.

I have my second LM at the same line. These messages are there too but in different times. The only explanation I've found is there were cuts or power failures on the bus but they're too short so they weren't detected by both LMs. Do you have any better idea?



Printscreen attached.

Attached Files Thumbnail(s)
   
LM5Lp, firmware: 2018.08.22 and 2021.12.15, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151 and 4.4.259
Reply


Messages In This Thread
KNX/TP: Conected - by Thomas - 05.06.2017, 17:16

Forum Jump: