08.06.2017, 12:06
Hi,
I use ETS5. I'm connected to KNX via LM.
Everytime I try to read a 4 bytes value which is filtered out I get "Connection lost" followed by "red circle" in the connection statusbar in ETS Diagnostics tab.
Both of my LMs (first has actual firmware, second uses the most recent RC) are affected by this issue. If I uncheck IP>TP filter then everything is OK.
Unfortunately I can't say if the problem is in LM or in ETS because I don't have any other way how to connect to KNX.
Printscreens attached.
I use ETS5. I'm connected to KNX via LM.
Everytime I try to read a 4 bytes value which is filtered out I get "Connection lost" followed by "red circle" in the connection statusbar in ETS Diagnostics tab.
Both of my LMs (first has actual firmware, second uses the most recent RC) are affected by this issue. If I uncheck IP>TP filter then everything is OK.
Unfortunately I can't say if the problem is in LM or in ETS because I don't have any other way how to connect to KNX.
Printscreens attached.
LM5Lp, firmware: 2018.08.22 and 2021.12.15, FlashSYS v2, ARMv7 Processor rev 5 (v7l), kernel 4.4.151 and 4.4.259