This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Gateway v
1-wire parasitic mode

Linear Mode
1-wire parasitic mode
Bobby Offline
Member
Posts: 88
Threads: 19
Joined: Aug 2016
Reputation: 1
#3
24.07.2017, 09:00
(24.07.2017, 08:49)admin Wrote: It is supported, no external resistor is required. Still, it is strongly recommended to use additional +5V supply, otherwise readings may fail due with larger cable lengths and/or a larger number of 1-Wire slaves.

Hi!

Ok, my tought was to use the 2 extra wires in the KNX cable.
tried it With GND and DQ, but did only get devices into lm, but no data. Sad
Find
Reply


Messages In This Thread
1-wire parasitic mode - by Bobby - 24.07.2017, 07:35
RE: 1-wire parasitic mode - by admin - 24.07.2017, 08:49
RE: 1-wire parasitic mode - by Bobby - 24.07.2017, 09:00
RE: 1-wire parasitic mode - by Bobby - 24.07.2017, 12:08
RE: 1-wire parasitic mode - by admin - 24.07.2017, 12:45
RE: 1-wire parasitic mode - by zoltan - 27.07.2017, 15:05

Forum Jump: