03.12.2015, 09:03
(02.12.2015, 22:45)FatMax Wrote: I´m scratching my head a bit concerning what to do if there is a fire alarm. Obviously, it´s fairly easy to turn off things that need to be turned off.
My concern regards lights. Is there a way, in a script, to poll every lights current status and save that state if the group address for the firearm goes true?
The scenario would be this:
Fire alarm goes off. Every appliance turns off and all lights go to 100%. 3 minutes after the fire alarm has been reset, the lights go back to the state they were in before the fire alarm went off.
I´m not even sure if this is what people do when it comes to KNX and fire alarms...
what we do:
- connect all devices to a scene
- when firealarm on: save scene - turn lights on / blinds up
- when firealarm off: call scene